Icom 756 PRO3, KV TRX HF+50MHz

Nabízím transceiver ICOM 756 Pro3 ve velmi dobrém stavu, první majitel, používáno pouze občasně. Možnost úplného a pečlivého vyzkoušení a předvedení v provozu. Pro3 má velmi dobré parametry citlivosti, odolnosti a selektivity na všech pásmech, nezaměnitelné se staršími modely řady 756.


GENERAL
Type: Amateur HF/VHF transceiver
Frequency range: TX: 10-160 m + WARC / 50-54 MHz
RX: 0.03-60 MHz
Tuning steps: 1 Hz, 0.1 / 1 / 5 / 9 / 10 / 12.5 / 20 / 25 KHz
Frequency stability: Better than ±0.5 ppm (-10 to +50°C / +14 to +122°F)
Mode: AM / FM / SSB / CW / RTTY
Channels / memory management: 99 regular
2 scan edge
Non-volatile EEPROM storage
Repeater shift / offset: ±0 to 4 MHz in 1 KHz steps
Power supply: 13.8 VDC ±15%
Current drain / power consumption: RX: Max 3.5 A
TX: Max 23 A
Antenna impedance / connector: 50 ohm / 2*SO-239
Dimensions (W*H*D): 340*111*285 mm (13.4*4.37*11.22")
Weight: 9.6 Kg (21.16 lb)
Other features: 32 bit IF-DSP. Built-in RTTY demodulator and auto-ATU. IP3 = +30 dBm.
Built-in keyer. 5" color TFT. CI-V computer control.




RECEIVER SECTION
Receiver system: Triple-conversion superheterodyne
1st IF: 64.455 MHz
2nd IF: 455 KHz
3rd IF: 36 KHz
Sensitivity: AM (10 dB S/N, 6 KHz BW)
0.5-1.8 MHz: 13 uV
1.8-30 MHz: 2 uV (Pre-amp 1 on)
50-54 MHz: 1 uV
FM (12 dB SINAD, 15 KHz BW)
28-30 MHz: 0.5 uV (Pre-amp 1 on)
50-54 MHz: 0.32 uV (Pre-amp 2 on)
SSB/CW/RTTY (10 dB S/N, 2.4 KHz BW)
1.8-30 MHz: 0.16 uV (Pre-amp 1 on)
50-54 MHz: 0.13 uV (Pre-amp 2 on)
Selectivity: AM (BW=6 KHz)
>6 KHz (-6 dB), 12 KHz (-6 dB)
2.4 KHz (-6 dB)
500 Hz (-6 dB)
70 dB
AF output power / speaker: 2 W at 10% distortion / 8 ohm
External speaker connector: 3.5 mm, 8 ohm




TRANSMITTER SECTION
RF output power:

Pwr
AM: 5-40 W
FM: 5-100 W
SSB (PEP): 5-100 W
CW (DC): 5-100 W
RTTY: 5-100 W

100% duty cycle
Modulation system: AM: Low power modulation
FM: Phase modulation
SSB: PSN modulation
Max FM deviation (Factory set): ±? KHz
Spurious emissions: HF: Better than -50 dB
VHF: Better than -60 dB
Microphone impedance / connector: 600 ohm / 8-pin (Metal locking ring connector)
Microphone input level: ? mV